“CREATED BY AUDIOPHILES WITH AN EXTRAORDINARY PASSION FOR HIGH-FIDELITY”
Car Audio Magazine
Technical Specifications:
Woofer Size: 5.25”, midrange Size 4", Tweeter Size 2"
RMS Power handling: 500 Watts per channel (200W - 500W RMS per channel is recommended)
Sensitivity: 90 db @ 2.83V
Frequency Response: 39-40,000 hz
Motor Type: Internal NEO Magnet (TWEETER MIDRANGE and WOOFER)
Voice Coil Type: Ultra-High Temp Single 4 ohm Coil
SYSTEM Impedance: 4 ohm nominal
Crossover Network: 3-way 24db/oct
for ACTIVE 3 way component setup use 2 amplifiers
Critical MASS 4CH amplifier model # ELS-1000.4 For active crossover set ELS-1000.4, front channels to 3Khz Hi-pass and connect to tweeters only. Set rear channels to 1Khz Lo-pass and connect to Woofers only. Critical MASS 2CH amplifier model # ELS-1000.2 For active crossover set ELS-1000.2, Band Pass Mode. set Hi Pass to 1Khz and set Lo Pass to 3Khz and connect to midranges only.
ULTRA-PERFORMANCE LIGHTWEIGHT 4 OHM DESIGN:
This component kit is an Ultra-Performance 5.25" Component kit made to use every watt from your 4 ohm amplifier
This set handles up-to 7 times more power, has a considerably higher linear and maximum excursion, and
audibly lower distortion, while weighing as much as 66% less than the competition.
HYBRID CARBON FIBER CONE:
This cone is made of Lightweight rigid fiber and oversized real Carbon fiber cap to withstand more than 1000 Watts of peak music power.
The Lightweight Carbon Fiber Cone hybrid increases rigidity, efficiency and clarity at all levels which ultimately means more, undistorted sound.
Included in this pro 3way 4 ohm kit:
- Two 5.25" Woofers
- Two 4" Midrange
- Two 2" tweeters
- Two 24db/oct Crossover networks (3way)
ALL PRODUCT, PRODUCT SPECIFICATIONS AND DATA ARE SUBJECT TO CHANGE WITHOUT NOTICE